AIR IN
AIR OUT
VENTILATION
Ventilation Control
When the AIR IN and AIR OUT
buttons are in the out position, the
vent door is closed and only the air
inside the room can be circulated
and conditioned.
Push the AIR IN button and it will
stay in, and the vent door will open
to allow a small amount of outdoor
air to enter the room. Push the AIR
IN
button again and it
return to
the out
and the vent door
will close.
Push the AIR OUT button and it
will stay in, and the vent door will
to allow air, smoke and odors
exhausted from the room.
the AIR OUT button again
and it will return to the out position
and the vent door will close.
For normal cooling
1. Set the Selector Switch at HIGH
COOL.
2. Set the Thermostat Control at
the desired number (usually 5-7 is a
good starting position). If room
temperature is not satisfactory after a
reasonable time, set the Thermostat
Control at a higher number for a
cooler room or at a lower number
for a warmer room.
3. Set the Energy Saver Switch at
NORM position for continuous fan
operation or at SAVE position to
automatically cycle the fan on and
off with the compressor.
4. Be sure the AIR IN and AIR
OUT buttons are in the out position
except for brief periods when you
to bring outdoor air into the
or exhaust room air to the
outside.
For maximum cooling
1. Set the Selector Switch at HIGH
COOL.
2. Turn the Thermostat Control
to
10.
3. Be sure the AIR IN and AIR
OUT buttons are in the out
position.
4. Set the Energy Saver Switch at
the NORM position.
For quieter operation
1. Set the Selector Switch at LOW
COOL position.
2. Turn the Thermostat Control to
the desired number.
When the Thermostat Control is set
on 9 or 10 and the Fan is set on low
speed, moisture may freeze on the
coils and prevent the unit from
cooling. If this happens, set the Fan
at high
and set the Thermostat
Control to a lower number.
3. Be sure the AIR IN and AIR
OUT buttons are in the out position
4. Set the Energy Saver Switch at
the NORM position.
Note: When the Energy Saver
Switch is at the SAVE position,
changes in the sound level may be
more noticeable than when it’s at
the NORM position.
For nighttime operation
During the cooler evening hours,
we recommend that you set the
Selector Switch at LOW COOL for
very quiet operation and the
Thermostat Control at mid-range
(5 or 6). Be sure the AIR IN and
AIR OUT buttons are in the out
position, and set the Energy Saver
Switch at NORM or SAVE position.
For extreme temperatures
For greatest economy and best
performance, we suggest that you
set the Selector Switch at HIGH
COOL in extremely hot weather.
To adjust air direction
Up and down
The up-and-down air direction
louvers are controlled by fingertip
pressure on the louvers. They
regulate air discharge upward,
downward or straight out.
Side to side
ON
CIRCULAIRE
OFF
For
side-to-side air
direction, set the Circulaire Switch
to ON until the desired air direction
is obtained, then move it to OFF.
For continuous side-to-side air
circulation, set the Circulaire
Switch to ON and leave it there.
5
