Horizontal louvers
on the front grille
let you control the
air direction up
and down.
Remove the front
grille to adjust the
vertical louvers
side-to-side to
direct the air left
or right.
9
Temperature Limiting
Limiting the maximum and minimum settings
prevents users from turning the control to the
extreme heat or cool positions.
The normal range of the temp control is
approximately 60°F to 85°F. The control range
may be narrowed by the use of the temperature
limiting screws located behind the control panel.
Each position equals approximately 3°F.
Air Direction
Fan Switch
To reach the fan switch(es) remove the
front grille.
On Heat/Cool and Heat Pump models,
the fan switch
levers are located in holes accessed through the
control box. The top switch is for
COOL
settings
and the bottom switch is for
HEAT
settings.
Use a small screwdriver to change the setting.
The unit is shipped from the factory set in the
CONT
setting for
COOL
and in the
CYCLE
setting
for
HEAT
.
Cool only models
have a rocker switch on the
front of the control box.
When set at
CYCLE
(down) the fan cycles on and
off when cooling. When set at
CONT
(continuous,
up) the fan runs all the time, providing a more
balanced temperature. The unit is shipped in
the
CONT
setting.
ge.com
Limits
heat
temp
Limits
cool
temp
Safety Instructions
Operating Instructions
Care and Cleaning
Installation Instructions
Tr
oubleshooting T
ips
Consumer Support
Vent Control
The vent control is located behind the front
grille on the right side of the air discharge area.
When set at
CLOSE,
only the air inside the room
will be circulated and conditioned. When set at
OPEN,
some inside air is exhausted outside.
To open or close the vent:
1. Remove the front grille.
2. Remove the vent card screw.
3. Remove vent card, turn it over and replace
it by locating rear hole in card over locating
pin inside air discharge and reattaching
screw at front.
Locating hole
Screw hole
OPEN position
(Mesh end toward back)
CLOSE position
(Mesh end toward front)
Locating hole
Screw hole
The unit leaves the factory set at the CLOSE position.
(Depending on model)
or
