September 2007
4
HygroTrace Moisture Transmitter
Standard Wiring Connections
Note:
The
HygroTrace
is not certified for use in Hazardous
(Classified) locations.
This procedure is for those units not connected to a computer.
The transmitter must be wired using the factory-supplied cable
(two meters in length). If an alternate length is required, please
contact the factory for assistance.
Note:
If cables need to be lengthened, refer to Table 1 on page 5
to splice an extension onto the existing cable. Connect
positive to positive and negative to negative.
Use the following steps to wire the transmitter to the system.
1.
Align the red dot with the red mark (see Figure 3 below) and
push the connector on the transmitter cable into the mating
connector on the transmitter module. Make sure the pins are
properly aligned. Once it is inserted, push the cable connector
until it locks into place.
Figure 3: Transmitter Cable Connection
