GE 5100 Series, Owner'S Manual

Page: 20 / 24

20
Zoneline
Doesn’t Start
Zoneline Does Not
Cool or Heat as it
Should
The unit is unplugged
•
Make sure the Zoneline plug is
pushed completely into the outlet.
The fuse is blown/circuit
•
Check the house fuse/circuit breaker
breaker is tripped
box and replace fuse or reset the breaker.
The unit is waiting for the
•
This is normal. The Zoneline will start
compressor overload
again after it resets.
protector to reset
Problem Possible Causes What to Do
Airflow is restricted •
Make sure there are no curtains, blinds
or furniture blocking the front of the
Zoneline.
The temp control may •
Turn the control to a lower or higher
not be set high or low
number.
NOTE: The temperature limiter may
enough be limiting the temperature range.
The air filter is dirty •
Clean the filter at least every 30 days.
The room may have been •
When the Zoneline is first turned on
hot or cold
you need to allow time for the room to
cool down or warm up.
Air is escaping •
Set the vent control in the
CLOSE
position.
If Something Goes Wrong
Before you call for service