11
e) Install the
Rubber End Caps after all the Reflector Rods are
assembled into the
Reflector Brackets.
f) Connect the two assembled halves of the
Reflector Brackets
together by aligning the connecting tabs and sliding the halves
together until the halves are evenly aligned (Fig. 3c).
Fig. 3c
4) Assembling the Assembled Antenna Main Boom to the Assembled
Reflector
a) Slide the metal end of the antenna
Main Boom through the center
of the
Reflector from the concaved side of the Reflector until the
bolt holes align with the bolt holes on the
Reflector Brackets.
b) Slide the two
M6 X 12mm Flat Washers onto the two M6 X 10mm
Bolts.
c) Screw in the bolts through the
Reflector Bracket top and bottom
into the antenna
Main Boom until bolts are tight. The finished
assembly should look like the illustration in (Fig. 4a).
Fig. 4a
d) Remove the
Wing Nuts from the “U” Bolt.
e) Insert the
“U” Bolt through the metal portion of the antenna Main
Boom from the jagged notched side of the antenna Main Boom
(Fig. 4b).
Fig. 4b
f) Thread the
Wing Nuts partially back onto the “U” Bolt; do not
thread
Wing Nuts all the way down at this time.
