31
NOTE:
If more than 2 handsets have been registered, you can page all handsets by
pressing 5.
4. To cancel the page, press the *EXIT button, or press the INT button. Or you may press
TALK•CALL BACK on the receiving handset to enter intercom mode.
Paging from the Base/Group Page
(This is ONLY applicable with addition of Model 25832A optional handset)
Use the base-only to page one or all registered handsets at the same time.
1. Press the page button on the base. All registered handsets beep for two minutes, and
PAGING FROM BASE
shows on each handset’s display.
2. To cancel the page, press the page button on the base, or press the TALK•CALL BACK
button or the *EXIT button on each handset.
Mute
To have a private, off-line conversation, use the MUTE feature. The party on the telephone
line cannot hear you, but you can hear them.
1. Press the MUTE/PROG button. The handset display shows
MUTE ON
.
2. Press the MUTE/PROG button to cancel and return to your
phone conversation.
Receiver Volume Control
When the handset is ON (in talk mode) you may adjust the receiver volume by pressing
the CALLER ID-VOL (
or
) button. There are four volume levels to choose from. When
the maximum or minimum volume level is reached, the phone beeps twice. VOL 1 is
minimum and VOL 4 is maximum.
Do Not Disturb (DND)
DND allows you to turn off the ringer on the handsets and call screening on the answerer
at once even though the handsets have been set to High or Low. To do this,
1. In the standby mode, press the DO NOT DISTURB button on the base. The DND backlit
indicator will turn on and “
DO NOT DISTURB
” shows in each handset display.
2. To cancel, press DO NOT DISTURB again.
NOTE:
You can also enable DND even when there is incoming call ringing in.
NOTE:
You can also enable DND to stop the call screening after the call is taken by
the answerer.
NOTE:
Enabled DND will also turn off the answering system new message alert
tone if it is set to ON in the handset menu.