DFR PS1
9
TROUBLESHOOTING
A.
Should the power lamp on the power supply fail to light, insure that power to
the line cord is being supplied. If power is on the line cord, check and replace
the fuse in the fuse holder on the rear of the power supply. As a final measure,
the power supply should be replaced and returned.
B.
Should the power LED on all individual plug-in modules fail to light, check the
following:
a.
The power lamp on the power supply should be lit.
b.
The 10-pin connector from the power supply should be firmly connected to
its mating connector on the back plane and located at slots 15-17 (The
optional secondary power supply should be located at slot 12-14).
c.
All Plug-in modules should be firmly seated into their respective 10-pin
back plane mating connectors.
If the above conditions have been met, the rack should be replaced and returned.
C.
Should the power LED on an individual plug-in fail to light, check the following:
a.
The plug-in module should be firmly seated onto the 10-pin connector on
the back plane.
b.
The fuses on the module should be intact. If not, return the module for
repair.
CAUTION!
This product is designed for indoor use only. Do not attempt to
deploy the product for outdoor use. Damage to the product can result.
