05-3946A01, Rev. C
TransNET OEM Integration Guide
1
1.0 ABOUT THIS MANUAL
This manual is intended to guide technical personnel in the integration of
MDS TransNET OEM™ transceivers into existing electronic equipment. The
OEM transceiver is designed for use inside Remote Terminal Units (RTUs),
Programmable Logic Controllers (PLCs) and other equipment associated
with remote data collection, telemetry and control.
The manual provides instructions for interface connections, hardware
mounting, and programming commands. Following integration of the trans-
ceiver, it is recommended that a copy of this manual be retained for future
reference by technical personnel.
2.0 PRODUCT DESCRIPTION
), is a compact, spread spectrum wireless
module designed for operation in the 900 and 2400 MHz license-free
frequency bands. It is contained on one double-sided circuit board with all
necessary components and RF shielding included. It need only be protected
from direct exposure to the weather and is designed for rugged service in
extreme temperature environments.
The transceiver has full over-the-air compatibility with standard (non-OEM)
TransNET transceivers manufactured by GE MDS. All transceiver program-
ming is performed via a personal computer or terminal connected to the
module. There are no manual adjustments required to configure the trans-
ceiver for operation.
Invisible
place
holder
Figure 1. TransNET OEM™ Transceiver
The transceiver employs Digital Signal Processing (DSP) technology for
highly-reliable data communications, even in the presence of weak or inter-
fering signals. DSP techniques also make it possible to obtain information
about the radio’s operation and troubleshoot problems, often eliminating the
need for site visits.
Using appropriate software at the master station, diagnostic data can be
retrieved for any radio in the system, even while payload data is being trans-
mitted. (See
