GE MDS Mercury 3650, Reference Manual

Page: 58 / 211

05-4446A01, Rev. E Mercury Reference Manual 49
• VLAN Status —Defines whether the radio handles Ethernet
frames in “extended” 802.1Q mode or in “normal” mode in the
Ethernet port. If configured with a trunk port, the Mercury
passes all tagged traffic regardless of the VLAN ID. The Mer-
cury only uses the
Data VLAN ID parameter when the
ETH
port is
configured as an Access Port.
[
enabled, disabled; disabled ]
• VLAN Ethport Mode —Defines if the Ethernet port acts as a trunk
port or as an access port. Auto mode defines the port as a trunk
port in an AP, or an access port in a Remote radio.
[
Auto, Trunk, Access; Auto ]
• Management VLAN ID —Defines the VLAN ID for traffic directed
to the radio itself, other than the terminal server process. This
VLAN ID is used for filtering and for tagging purposes.
[
1-4094; 2 ]
• Data VLAN ID —Defines the VLAN ID assigned to traffic directed
to and from the Ethernet port and the terminal server process in
the radio. This VLAN ID is used for filtering and tagging pur-
poses. [
1-4094; 3 ]
• Default Route IF —Defines the VLAN that contains the default
gateway in the radio. [ MGMT, DATA; MGMT ]
• Management VLAN Mode —Applies the VLAN tag to management
frames. [ Tagged, Native; Tagged ].
• Management VLAN Subnet Config —Presents a screen where you
can set the IP Address Mode, Static IP Address, and Static IP
Netmask (see
Figure 3-16 on Page 50 ).
• DHCP Server Config (Mgmt) —Presents a screen where you can
view or set the DHCP server status and address information for
management functions (see
Figure 3-17 on Page 51 ).
• Data VLAN Subnet Config —Presents a screen where you can view
or set the IP mode and address information (see Figure 3-19 on
Page 52 ).
• DHCP Server Config (Data) —Presents a screen where you can view
or set DHCP server status and address information for data
functions (see
Figure 3-18 on Page 52 ).