Operating the CyberScout
CyberScout User Manual
32
1038864A / December 2002
After programming the CyberScout ShadowTour and recalibration
macros into the KTD-404 keypad, the keypad will let you:
•
Program a 4-minute ShadowTour
: Program a 4-minute
ShadowTour by using the assigned ShadowTour macro key. Press
the macro key once to start recording a ShadowTour. Begin the
manual operation sequence you want to record as your
ShadowTour. Press the macro key again to stop recording the
ShadowTour. Follow your keypad’s instructions for activating the
ShadowTour.
•
Recalibrate a CyberScout
: Recalibrate a CyberScout by pressing
the recalibration macro once. Refer to section
4 Troubleshooting
for the proper use of the recalibration macro.
Note:
CyberScouts should not be recalibrated unless it is necessary. Refer to
section
4 Troubleshooting
to learn when to recalibrate your CyberScout.
To program CyberScout macros, first, add macro functionality to the
keypad:
1)
Remove the four screws from the bottom of the keypad and
carefully open the keypad. Do not pull on the cabling that connects
the two internal circuit boards.
2)
Set DIP switch 7 to ON. If necessary, refer to the keypad manual.
3)
Reattach the bottom of the keypad with the four screws.
Continue by programming a key on the keypad to be the macro key:
1)
Beginning at the normal operating display, enter programming mode
by pressing and holding the
set
key. Quickly move to the next step
after the keypad beeps and the code entry display appears.
CAMERA 000
MONITOR 01
Figure 30. Normal operating display
