Quickstart Guide
C2
Quad Protector
Controller with
Remote GASMAX EC Gas Monitor
GDS Corp. 2513 Hwy 646 Santa Fe, Texas 77510 (409) 927-2980 (409) 927-4180 fax
www.gdscorp.com [email protected]
C2 QUAD ANALOG INPUT BOARD
P/N #10-0221-4
Wiring & Initial Setup Instructions
1) Install the C2
Quad Protector
controller and remote
GASMAX EC gas monitor. As with all sensors, avoid
locations subject to excessive heat, directed water spray
or dust. A splash guard is recommended on all externally-
mounted sensors.
2) Connect the C2 Quad Protector input terminals to the
remote GASMAX EC monitor as shown below. The
GASMAX EC output is non-polarized; either wire can be
connected to the +24VDC excitation pin.
3) Make sure the selected C2 channel is set to “ON” (see
the C2 manual, section 2.2.4d).
4) Calibrate the unit to verify proper operation.
GASMAX / EC DISPLAY ASSEMBLY
P/N #10-0232
Important:
The GASMAX / EC loop output
is non-polarized. Either
GASMAX / EC output may be
connected to the +24VDC
terminal on the C2 Quad.