Quickstart Guide
C2
Quad Protector
Controller with
Remote GASMAX II Gas Monitor
GDS Corp. 2513 Hwy 646 Santa Fe, Texas 77510 (409) 927-2980 (409) 927-4180 fax
www.gdscorp.com [email protected]
C2 QUAD ANALOG INPUT BOARD
P/N #10-0221-4
Wiring & Initial Setup Instructions
1) Install the C2
Quad Protector
controller and remote
GASMAX II monitor. As with all sensors, avoid
locations subject to excessive heat, directed water
spray or dust. A splash guard is recommended on
all externally-mounted sensors.
2) Connect the C2 Quad Protector input terminals to
the remote GASMAX II monitor as shown below.
3) Make sure the selected C2 channel is set to
“ON” (see the C2 manual, section 2.2.4d).
4) Calibrate the unit to verify proper operation.
GASMAX II POWER SUPPLY
ASSEMBLY BOARD
P/N #10-0233
S2
Ribbon to Display
1 2
4
3
PW
R
O
U
T
4-
20
“ECHE
M”
O
U
T
4-
20
“L
E
L
”
GND
RE
F
COM
AC
T
CATBEAD
S1
C7
C8
C1
C2
I/O Power Supply
Assy 10-0233
TB1
TB2
Important:
The GASMAX II output is
polarized. Take care in
connecting the +24VDC
source, 4-20mA output and
ground reference wiring.