GDH GDH70-Air, Installation And Operating Manual

Page: 6 / 24

PRE-INSTALLATION
The heat pump should never be stored or installed on its side. Upright
transportation is recommended. If it becomes necessary to transport the heat
pump on its side, the manufacturer recommends that the unit be in the upright
position for a minimum of two hours prior to operation. Failure to follow these
instructions may result in damage to the heat pump.
After removing the unit from the crate/carton, immediately remove the
panels and inspect for any damage that might have occurred during shipment.
Report concealed damage immediately to the transportation company and
request inspection.
The electric power source must be the same voltage and phase as shown on the
rating plate. Line and low voltage wiring must be done in accordance with local
codes or the national electric code.
The heat pump must be installed by authorised installation engineers and the
installation must follow the applicable local rules and regulations as well, as
these installation instructions described in this manual.
We reserve the right to change the specifications within this publication in whole
or in part without prior notice. This brochure is to be used as a general guide and
does not form any part of a contract or is binding in any way. We reserve the
right when necessary, or at our discretion to use alternative suppliers or
components manufactured by other suppliers.