5. CABLE CONNECTIONS
May 18, 2016
17
HFR UPGRADE MANUAL
FOR SX-2001/SA-2100(A/T) TO SX-000(A/T)R
DIGITAL CINEMA SERVER WITH
INTEGRATED MEDIA BLOCK
5.
CABLE CONNECTIONS
Once the server has been placed in the desired location, the cables described below should
be attached (See Figure 14).
1
VGA cable used for connecting to external touch screen monitor
2
Power cables
3
Network connections:
eth0
– Projector
eth1
– IMB interface
eth2
– Management
4
USB slot used for connecting to external touch screen monitor
Figure 14 SX-2000 rear panel with cables attached
5.1
Ethernet Connections
1. Make sure the IMB is powered up inside the projector correctly.
2. SX-2000(A/T)R eth0 IP must NOT be 192.168.1.X (recommend it to be 192.168.0.X).
3. SX-2000(A/T)R eth0 is connected to projector Ethernet (either directly or via switch).
4. SX-2000(A/T)R eth2 IP must NOT be 192.168.1.X.
5. SX-2000(A/T)R eth1 is directly connected to IMB Ethernet 2. eth2 is available after
installing the additional gigabit network card.
IMPORTANT NOTE:
Projector should not use 192.168.2.X IP as this IP range is reserved
for
IMB internal use. If projector IP is set to 192.168.2.X, the server will not be able to
connect to the security manager (SM) after upgrade.
