DU-AG-0021-25 Rev C 1/09/07 GCX Corp. Page 3 of 7
2. While supporting the bottom of the Arm, guide the Slide into the top of the wall channel (below left) and move Arm to
required mounting position.
3. Using the 1/8'' hex wrench provided, tighten four (4) set screws in Slide to secure position of Arm (below right).
Mounting the Monitor
1. Mount the monitor in accordance with Philips Table Top Mount instructions, or follow procedure below for
non-table
top mount
. Proceed to
"Counterbalance Adjustment"
on page 4.
MP20/30 with non-Table Top Mount
1. Fit Spacer into recessed area on top of Mounting Adapter (below). Ensure Spacer remains between Mounting Adapter
and monitor.
2. Insert two (2) M6 x 16mm PHMS through bottom of Mounting Adapter and thread into mounting holes in bottom of
monitor (right).
Insert Slide
Set Screws (2 lower)
Set Screws (2 upper)
Mounting Adapter
Spacer
