GCC Technologies Spirit, Maintenance Manual, Page: 126 / 160

Spirit/Spirit LS/Spirit GLS Maintenance Manual V.6
126
Message
Z motor malfunction For service please contact your local distributor
Cause
Z motor is abnormal
Solution Verification:
1. Check if the cable connections of Z motor are correct
2. Check if there were any abnormal sounds from Z motor
Solution:
1. Re-install the motor cable
2. Adjust the speed of table moving
Message
Laser Warming Up Please Wait
Cause
Laser tube is warming up
Solution Wait for the laser tube warm up
Message
Please install the Auto Focus pin first before performing Please press
any key to stop
Cause
Auto Focus pin is abnormal
Solution Check Auto Focus pin
Message
CCD Error! Move carriage to first mark or reset CCD Thank you
Cause
CCD didn’t recognize the object successfully
Solution Do the recognition again.
Message
CCD Offset Error Please change your media or confirm CCD
focus distance
Cause
The pattern is too close to the boundary and the carriage goes out of
the boundary after the recognition is finished.
Solution Move the pattern to the center of the table