GCC Technologies Jaguar IV Series, Maintenance Manual

Page: 55 / 68

55
Check Lever Sensor
Enter Key
4.1.2 Diagnostic Test for SRAM and DRAM
This test provides the ability to diagnose the SRAM and DRAM. If these two components are bad,
replace them. Otherwise the cutting plotter will not work properly.
4.1.3 Diagnostic Test for Lever Sensor
This feature diagnoses the lever sensor. If the sensor is faulty, the cutting plotter cannot sense that the pinch rollers have
been lowered or not. If the lever sensor is down, you will see a lift the lever message on the LCM. If the lever is up, you will
see a lower the lever message on the LCM. You can use the ON/OFF LINE KEY to abort your test when you have finished
the lever sensor test.
Up/Down
Cancel Key
Display lever
sesor condition messages Previous/Next Test item
Note that: LCM will display one of following messages
1.Lower The Lever Please
CANCEL
2.Lift The Lever Please CANCEL
The first message means that the current lever condition is up
The second message means the lever is down