Expert 24 User Manual
Installation 2-5
Figure 2-6
Pin
Outward ring
Adjustment depth knob
2.3 Blade Installation
Figure 2-6 is the illustrator of the blade
holder. Insert a blade into the bottom of
the blade holder and remove the blade by
pushing the pin. Make sure that your fingers
are away from the blade tip.
Step 1 Step 2
Install blade (Figure 2-7). Push the blade to the bottom of the blade
holder (Figure 2-8).
Step 3
Adjust the blade tip to suitable length by
screwing “Blade tip adjustment screw”
clockwise or count-clockwise. (Figure 2-9).
Tips:
“The proper length” means the blade’s
length is adjusted 0.1mm more than film’s
thickness. That is, if the thickness of film is
0.5mm, then blade’s length is properly
adjusted 0.6mm and it can completely cut
through the film layer yet avoid penetrating
the backing.
Figure 2-8
Figure 2-9
Figure 2-7
