Expert Pro User Manual
Operation 4-1
Chapter 4 Operation
4.1 Media Loading
4.1.1 Loading the Sheet Media
To load the media properly, please follow the procedures listed below:
Pull the lever upward to raise the pinch rollers. (Figure 4-1)
Load your media on the platen and slide it under the pinch rollers from either the front side or
the backside. The alignment rulers on the platen extension will help you to adjust the media
precisely.
Note:
Be sure that the media must be covered by the paper sensors on the
platen when loading the media. At least one of the two paper sensors
should be covered. Once the media covers the sensor, the cutting plotter
will size width and length of media automatically.
Then move the pinch rollers manually to the proper position. Be sure the pinch rollers must be
positioned above the grid drum. The white marks on top trail will help you position pinch rollers
when media on the platen. (Figure 4-2)
Figure 4-1
Paper sensor
