4.0 OPERATING INSTRUCTIONS
4.1
Punching
1. Adjust the punch edge guide to the correct paper length. Check the punch
alignment by punching a sheet of paper and folding it in half along the punched
edge (See Figure 4-1). Match the holes up: if the corners of the paper match
with no overlap, the alignment is correct. If not, readjust the guide and repeat
the process until the edges are square.
2. Place the paper fully in the punch throat and slide the paper to the left against
the punch edge guide. Lower the handle with a firm, even motion. Raise the
handle and remove the paper.
3. To prevent jamming, only 25 sheets of 20 pound bond paper should be punched
at one time (fewer sheets if the paper is heavier). Do not punch more than 4
composition covers or 3 plastic covers at one time.
Figure 4-1
4-1
