3.0 INSTALLATION
1.
Closely inspect the unit prior to opening. All shipping damage should be brought to the
immediate attention of the delivering carrier.
2.
Place the laminator on a stable flat surface capable of supporting at least 95 lbs. The surface
should be at least 30 inches high to assure comfortable positioning during operation. All four
rubber support feet should be positioned completely on the supporting surface. The supporting
surface may also be large enough to hold the material to be laminated.
3.
The laminator should be positioned to allow exiting film to drop freely to the floor. Accumulation
of laminate immediately behind the laminator as it exits the equipment may cause the film to wrap
around the pull rollers (wrap-up condition).
4.
Avoid locating the laminator near sources of heat or cold. Avoid locating the laminator in the
direct path of forced heated or cooled air.
5.
Connect the attachment plug provided with the laminator to a suitably grounded outlet only.
Avoid connecting other equipment to the same branch circuit to which the laminator is connected
as this may result in nuisance tripping of circuit breakers or fuses.
Please read the operating instructions thoroughly before operating your laminator.
3-1
Summary of Contents for Ultima 65
