5. Feature Guide
Figure 1
Figure 2
A.
MAIN POWER SWITCH:
Located at the back of the
machine, applies power to the laminator. The ‘ON’
position is indicated by the ‘
I
‘ symbol. The ‘OFF’
position marked ‘
O
’ symbol (figure 2).
Figure 3
B.
CONTROL PANEL:
a.
FOOTAGE COUNTER
– Tracks the number of feet
used since
last reset. To reset the footage counter
press the RESET button.
b.
ON/OFF BUTTON
–used to put the machine in
Standby mode or wake the machine up from
Standby mode.
i.
READY
– Machine is ready to use when
machine beeps and the
Icon LED turns
GREEN.
ii.
WARM-UP
– Machine is warming up when
the
Icon LED is AMBER.
iii.
STANDBY
– When
icon is illuminated
AMBER, machine is in Standby mode.
Press the ON/OFF button to wake the
machine and warm-up to operational
temperature.
c.
FILM SELECTION
– (1.5 OR 3 MIL) – Press the
film selection button to toggle between 1.5 and
3 mil films
d.
SPEED CONTROL
– Controls the speed of the
laminator when the run button is pushed.
i.
AUTOSPEED
– Machines runs at optimum
speed for the film type selected. PUSH the
speed dial to turn this feature ON/OFF.
GREEN
LED will illuminate when ON.
ii.
MANUAL SETTINGS 1 THRU 10 –
Operator
can manually select the speed 1 – 10. The
speed will increase as you adjust from 1 to
10. AUTOSPEED must be turned OFF to
manually adjust speeds
.
e.
RUN
– Push the RUN button to run the
laminator in the forward direction.
f.
SLOW FORWARD/REVERSE
– Press and Hold to
run the machine slowly in Forward or Reverse.
Using SLOW Speed will allow the machine to
run even when Heat Shield is open.
g.
STOP –
Used to Stop the laminator. There are
two stop buttons one on front panel and one
on back of the machine.
Figure 4
C.
HEAT SHIELD
: (figure 4) Prevents inadvertent
contact with the heat rollers. The HEAT SHIELD
must be lowered for the RUN operation to work.
D.
FEED TABLE
: (figure 4) The Feed Table is used to
position items for lamination. Feed table must be
closed and latched for laminator to operate.