![background image](http://html1.mh-extra.com/html/gbc/ricoh-streampunch-pro/ricoh-streampunch-pro_installation-manual_3875062003.webp)
Ricoh StreamPunch Pro, Pro EX & MP Installation Manual
3
a)
Remove the finisher rear
cover and plug the 7 pin
communication cable to
CN144 in the bottom left
corner of the SR5000
finisher board.
b)
Replace the finisher to
printer cable with the
longer cable provided.
Plug the 8 & 9 pin
connector’s into CN100 &
CN101 on the finisher
board. Replace the
finisher rear cover.
c)
Plug the free end of the
cable from step a) into the
right side of the
StreamPunch. Plug the
free end of the cable from
step b) into the connector
on the printer.
d) There are two entrance paper guides provided with the StreamPunch. Use the longer paper guide
measuring about 14” long when used in conjunction with the SR5000 finisher. Install the paper guide,
using the size #8 screws provided, to the lower entrance guide of the StreamPunch.
If installing the StreamPunch directly downstream from the printer, contact your local service
representative to obtain the correct entrance guide.
Go to Section 4 to complete the installation.