![background image](http://html1.mh-extra.com/html/gbc/gbc-2064wf-1/gbc-2064wf-1_installation-and-operating-manual_570975010.webp)
GBC 2064WF-1
Operation Manual
© 2009 General Binding Corporation an ACCO Brands CO. Page 10
FEATURES GUIDE
Refer to the following pages for detailed information on the above Features
FEATURES GUIDE (DETAILED DESCRIPTION)
FIGURE 1
FIGURE 2
FIGURE 3
A
EMERGENCY STOP BUTTONS:
(Fig. 1– Item A)
Four
Emergency Stops
buttons are available
on the Laminator on the top four corners of
the Laminator.
To engage Emergency -stop button, press any
emergency -stop safety push button to stop
the roller movement
To disengage turn the push button clockwise
after the emergency condition has been
resolved
Front Media Table:
The
Media Table
(Fig.2A) is used to position
items for Lamination. There are two media
tables on the machine one on the front & one
on the rear of the Laminator. The Front
Media table incorporates an Idler on the
leading edge of the table.
Infeed Idler:
The
Infeed Idler
(Fig.2C) is used for roll to
roll applications during lamination.
Pressure Plate:
The
Pressure Plate
(Fig. 2B) helps to keep
images flat and assists when feeding images.
Safety Interlock Switch:
On both the Front Media & Rear Media
tables, the
Safety Interlock Switch
(Fig.3A)
will not allow the Laminator to operate at full
speed unless the tables are properly installed.
Pressure Plate Release Lever:
The
Pressure Plate Release Lever
(Fig.3B)
will allow the operator to remove the Pressure
plate by pulling the lever out, releasing the
locking pin, and remove the Pressure Plate.
Note:
The Laminator will operate only when the
Media Table and Media Table Latch are
Properly Installed