GBC FOTON 30 Automated Laminator, Start Here Manual

Page: 4 / 54

4
Safety
YOUR SAFETY, AS WELL AS THE SAFETY OF OTHERS
IS IMPORTANT TO GBC. IN THIS INSTRUCTION
MANUAL AND ON THE PRODUCT ARE IMPORTANT
SAFETY MESSAGES. BEFORE YOU INSTALL OR
USE THE MACHINE, READ AND FOLLOW ALL THE
SAFETY NOTICES CAREFULLY IN THIS CHAPTER.
Observe all the safety information provided. Observe all
safety warnings. Never remove safety warnings or other
information from the equipment.
Read all of the instructions and save these instructions for
further use.
The safety alert symbol precedes each safety
notice in this manual. The symbol indicates a
potential personal safety hazard to you or
others, as well as cause product damage or
property damage.
Observe all the safety information provided.
Observe all safety warnings. Never remove
safety warnings or other information from
the equipment.
THE FOLLOWING WARNINGS ARE FOUND ON THE
FOTON 30 LAMINATOR
Do not open. No user serviceable parts insides. Refer
servicing to qualified service personal.
CAUTION Hot Surface: Laminator rollers can
be in excess of 260° F/ 126.7° C. Please use
caution and do not touch the rollers.
WARNING: Do not attempt to service or repair
the laminator.
WARNING: Do not connect the laminator to
an electrical supply or attempt to operate
the laminator until you have completely
read these instructions. Maintain these
instructions in a convenient location for
future reference.
WARNING: This device is not intended for use
in the direct field of view at visual display
workplaces. To avoid incommoding reflexions
at visual display workplaces this device must
not be placed in the direct field of view.
Service
To register and activate the warranty go to
ww.gbceurope.com
For details of your local service representative go to
www.gbceurope.com
Products marked with this symbol meet all
applicable Community regulations for the
European Economic Area.
Only use the laminator in indoor areas.
Controls
Power: turns on unit and
begins warming process,
press again to turn off.
Run/Stop: Starts and
stops lamination
Mode: Press to cycle
through operation modes.
Status indicator: used to
indicate Warming, Ready,
Running, and Error states.
Manual Feed
Ready indicator:
used to indicate when to
insert document in manual
feed modes
Activates Cutter: press
while in Manual Feed
/ Manual Cut Mode to
separate documents.
Important! Verify
completed document
before use
Film Status:
Low indicates approx. 30
documents remaining.
Empty indicates cartridge
must be replaced to
continue
Error States:
Door indicates a door
is ajar.
Jam indicates a document
jam.
Cutter indicates a cutter
error