Section 3
3-4
© Copyright 2009 GBC. All rights reserved.
Advanced Punch Service Manual
Figure 3.4 Damage from Backgage Gates
Root Cause:
The lead edge damage displayed in
enter the Backgage/ Punch area arriving as the Backgage Gates are closing.
Damage occurs in three areas aligning with each Backgage Gate.
Corrective actions:
•
Check/ replace pinch roll mounting and spring locations, especially those
located in the Entrance Aligner and E-Roller areas (roller immediately before
the Backgage Assembly).
•
Clean all pinch roller, Aligner Belts and E-Rollers with mild soapy water and
rinse with a damp, lint-free towel.
•
Check punch die by exchanging with another punch die (if available).
Excessive die wear will produce additional delay of sheets departing the
Backgage area.
Summary of Contents for AdvancedPunch
