![background image](http://html1.mh-extra.com/html/gbc/80-99/80-99_operating-and-maintenance-manual_4060629023.webp)
Page 5 - 9
Operations
Orca 80-99 Operation and Maintenance Manual
© GBC Films Group June 2000
C.
Raise Main Roll (Hot).
D.
Reverse Motor.
E.
2nd Pass: Set Nip Height and tack leading edge.
Run through as liner is being pulled off.
Cold Overlamination (Using a Sled)
1. Setup:
A.
Refer to charts 2-9 and 2-9B
B.
Set main roll shims to 3/16"
2. Procedure:
A.
Use a starter board to get the film started and
feeding without wrinkles.
B.
Lay image on the sled and place it up against the
leader board.
C.
Feed image through the nip following the leader
board into the nip. Maintain paper tension on the image
until it is through the nip.
D.
Cut around the image with a sharp knife to remove
it from the leader board.