![background image](http://html1.mh-extra.com/html/gbc/640t/640t_installation-and-operation-manual_3881944018.webp)
640t
– Installation and Operating Instructions
Page 5-6
p
oWer
Fig. 5-11. Power Panel.
a. o
n
/o
ff
p
oWer
s
Witch
The On/Off Power Switch is located at the back of
the machine. Press the “I” on the switch to turn it on.
The LCD will illuminate. The off position, marked “0”,
turns the machine off.
B. c
ircuit
B
reaker
The Circuit Breaker will trip if there is too much load.
Wait for 1 minute after the Circuit Breaker trips and
press the switch to reset. If the machine fails to reset,
see “Troubleshooting” on page 7-2.
c. n
omenclature
p
late
Technical information is provided on the
Nomenclature Plate:
Serial Number
•
Voltage
•
Amps
•
Watts
•
Hertz
•
p
oWer
c
ord
and
f
oot
s
Witch
Fig. 5-12. Power Cord and Foot Switch.
a. p
oWer
c
ord
The Power cord is a 220 VAC, NEMA 6-15P and fits a
NEMA 6-15R.
B. f
oot
s
Witch
The Foot Switch allows the operator to start and stop
the laminator while handling the item to be laminated.
Press the Foot Switch to run the laminator. Release it
to stop the laminator.
When the Foot Switch is used and the Safety Sensor
is blocked, the speed of the laminator drops to 3 fpm
(0.9 mpm).
When the Feed Table is removed, the rollers will
rotate if the Foot Switch is pressed. The machine will
run at 3 fpm (0.9 mpm)
Summary of Contents for 640T
