![background image](http://html1.mh-extra.com/html/gbc/5031ts-roll/5031ts-roll_instruction-manual_3875053006.webp)
GBC 5031TS
OPERATION MANUAL
© 2006 General Binding Corporation
5
CONTROL PANELS
FEEDER CONTROL PANEL
A
FEEDER ON/OFF SWITCH
(Figure 1)
A. Turns the Feeder ON/OFF
A. TABLE UP
Raises the table up for feeding. If the table is
down, it will happen automatically rise up to the
Pile Height switch when RUN is pressed.
B. TABLE STOP
Stops the table motor.
C. TABLE DOWN
Lowers the feed table for loading. The table will
not go down if the feeder or laminator are in the
RUN mode.
D. RUN
Starts the feeder motor.
E. STOP
Stops the feeder motor. Press and hold to reset
the counter
F. LENGTH ADJ.
Sets the length of the sheet.
G. GAP ADJ.
Sets the gap in between the sheets.
LED DISPLAY
(Figure 3)
A. Displays the selected sheet length
B. Displays the number of sheets fed
C. Displays the selected gap. At “0” there is
an automatic 1” gap.
D.
RUN/STOP:
Displays the operating
mode.
A. Main In-Feed Tire Adjustment Screws
Adjusts the in-feed tire pressure. Adjusting
these knobs controls the skew of the paper
from left to right. Only adjust one at a time.
B. Ball Bearing Rack
Drives the paper into the laminator. Heavier
sheets require additional ball bearings or
switching to the secondary feed tires.
SEE: Dual Feed Delivery System.
C. Paper guides:
Help direct the sheets into the laminator.
B
C
Figure 2
E
D
Figure 3
A
F
G
D
B
C
Figure 4
A
B
C
A
Figure 1