![background image](http://html1.mh-extra.com/html/gbc/44dt/44dt_installation-and-operation-manual_3868062023.webp)
Operating Instructions
Page 6-6
44DT
Insert the bearing end of the shaft into its
support on the right side of the machine, press
to the right, and then insert the left end of the
hex shaft into the brake hub.
Center each supply roll on the shafts by doing
the following.
Use a ruler to measure from the left edge of
the roll to the left side frame.
Do the same on the right side.
Shift the roll side to side so that both
measurements are equal. It is important that
the edges of the films are aligned so that
adhesive does not get on the rollers.
Center the take-up core on its shaft.
4.
5.
a.
b.
c.
5.
T
HERMAL
AND
A
CCU
S
HIELD
™ F
ILMS
C
ONFIGURATION
Thermal and Accushield films are loaded as shown
in Figs. 5-9 and 5-10. The top supply is in the front
unwind position. When loading thermal films, the
bottom supply shaft is also loaded. When loading
AccuShield films, nothing is loaded on the bottom
supply shaft and the separator bar must be in place.
If the top supply shaft is not positioned on the front
position, follow the instructions
below. When set up
properly, the brake assembly will be on the left as
you face the front of the laminator.
To move the supply shaft:
Unscrew the thumb screws on the brake
assembly and the shaft support brackets.
Fig. 6-8. Top Supply Shaft Brake Assembly in the
Rear Position.
Lift the brake assembly up and out of the
machine.
Lift the shaft support assembly up and out of the
machine.
Go to the opposite side (front or rear) of the
laminator and slide the brake housing over the
pins on the left side as you face the laminator.
Insert the thumb screw into the corresponding
hole and hand tighten.
Slide the shaft support assembly over the pins
on the right side of the laminator.
Insert the thumb screw into the corresponding
hole and hand tighten.
1.
1.
2.
3.
4.
5.
6.
Locating pins
Thumb screw
Summary of Contents for 44DT
