![background image](http://html1.mh-extra.com/html/gbc/44dt/44dt_installation-and-operation-manual_3868062022.webp)
Page 6-5
Operating Instructions
44DT
Remove the release liner from the take-up core
by doing the following.
Lift the right end upward and out of the
support and then pull the hex end out of
the support.
Unwind or cut the liner from the core.
Do not damage or throw away the core.
Put the shaft, with the core, back on the
machine by inserting the left end (hex
end) in the left side of the drive and lower
the bearing into the right side of the
machine.
To remove the film supply shaft, grasp the shaft,
press it to the right until the left end of the hex
shaft clears the brake hub, and raise the left end
of the shaft out of the machine.
Do this for the top and bottom supply shafts.
Slide the core off the shaft and core adaptors.
Tip:
Twist the shaft while pulling to remove the
core easier.
Clean all rollers and idlers if needed. See the
Operator Maintenance
chapter.
4.
a.
b.
c.
4.
5.
1.
To load films onto the supply shafts:
If the supply shaft is on the machine, remove it
by grasping it, pressing it to the right until the left
end of the hex shaft clears the brake hub, and lift
the left end out of the machine.
This applies to the top and bottom supply shafts.
Use the set screws in the core adaptors to move
the adaptors if needed. The grippers on the core
adaptors should be pointing in the opposite
direction that the film unwinds from the roll.
Fig. 6-6. Core Adaptors on the Shafts.
Fig. 6-7. Direction of Core Adaptor Gripper on Poly-in Film.
Slide the new roll on to the shaft and core
adaptors. Refer to Fig. 6-4.
Poly-in and Poly-out
Films to determine how the film unwinds from the
roll.
1.
2.
3.
Gripper
Supply shaft
Take-up shaft
Core adaptor
Gripper
Summary of Contents for 44DT
