Model Sekita Large
Please retain product label (Attached to your building) for reference with all future contact
Retain Instructions for future reference
1
2
3
Door x2
Before
commencing assembly
make sure you have a
suitable base ready to
erect your building
Door Gable
Plain Gable
5
6
4
Floor
2290x1542mm
x2
7
Length - 3118mm
Width - 2336mm
Height - 2112mm
Roof OSB
1330x1042mm
x6
Window Side x2
This building should be erected by
two people.
For ease of assembly, it is advisable to
pilot drill all screw holes and ensure
all screw heads are countersunk.
Plain Side x2
BEFORE YOU START PLEASE READ INSTRUCTIONS CAREFULLY
- Check the pack and make sure you have all the parts listed.
- When you are ready to start, make sure you have the right tools at hand
(not supplied) including a Phillips screwdriver, Stanley knife, wood saw,
step ladder and drill with 2mm bit.
- Ensure there is plenty of space and a clean dry area for assembly.
x2
Fixing Kit
8
9
10
Center Cover Trim - 95x1566mm x2
Cover Trim - 45x1566mm x4
TIMBER
As with all natural materials, timber can be a ected during various weather
conditions. For the duration of heavy or extended periods of rain, swelling of the
wood panels may occur. Warping of the wood may also occur during excessive
dry spells due to an interior moisture loss. Unfortunately, these processes cannot
be avoided but can be helped. It is suggested that the outdoor building is
sprayed with water during extended periods of warm sunshine and sheltered as
much as possible during rain or snow.
Our buildings are delivered pre-treated with a water based timber treatment
however this only helps to protect during transit of your garden item. To
validate your guarantee and for better protection against weathering it is
ESSENTIAL that you treat the garden building with a wood preserver within 3
months of assembly. This will need to be re-applied annually to ensure longevity
of your building. Care must be taken when constructing the garden building
that it is not touching the ground and is on a suitable base.
2mm Drill bit
17
18
19
20
21
Roof Support
Block x4
Winter = High Moisture = Expansion
Summer = Low Moisture = Contraction
Ridge Bar -1515mm x2
Finial x2
Door Strip - 1050mm
11
12
13
14
Fascia - 1300mm x4
Door Strip - 560mm
Roof Support Bar - 1208mm x4
Roof Eaves - 1042mm x6
BUILDING A BASE
When thinking about where the building and base is going to be constructed: Ensure that there will be access to all sides for maintenance work and
annual treatment.
TYPES OF BASE
- Concrete 75mm laid on top of 75mm hard-core.
- Slabs laid on 50mm of sharp sand.
Ensure the base is level and is built on rm ground, to prevent distortion. Refer to diagrams for the base dimensions, The bas e should be slightly
smaller than the external measurement of the building, i.e. the cladding should overlap the base, creating a run o for water. It is also recommended
that the oor be at least 25mm above the surrounding ground level to avoid ooding.
Whilst all products manufactured at Walton Garden Buildings Limited are made to the highest standards of Safety and in the case of childrens products
independently tested to EN71 level, Walton Garden Buildings Limited cannot accept responsibility for your safety whilst erecting or using this product.
Styrene
610x485mm x6
Window Strip (External) - 570mm x8
Window Strip (Internal) - 465mm x6
15
16
Ridge Bar
Support block
Qty 2