Gazer F122, User Manual

Page: 38 / 60

RU
38
Установка крепления на 3М скотче
Внимание! Перед установкой обезжирьте по верх­
ность лобового стекла. Убедитесь, что место установки
сухое и чистое. Не устанавливайте креп ле ние на 3М
скотче при температуре ниже +5°С. Из­за низкой
температуры возду ха, а также большого пе репада
температур между салоном автомобиля и улицей 3М
скотч потеряет свои свойства и не позволит надежно
зафиксировать крепление.
tape mount installation
Warning! Wipe the surface of the windshield before installing.
Make sure the place of installation is dry and clean. Do not install
the mount on 3M scotch tape at temperatures below +5°C. Due
to such low temperature and the difference between the
temperature inside the car and outdoors, the 3M scotch will lose
its adhesive properties and will not be able to fix the mount
properly.
Attach the MVR frame to the 3M scotch
mount.
Remove the protecting film from the
mount.
Fix the mobile video recorder on 3M
scotch tape to the selected place on
the windshield.
Loosen screw 1 by turning it
counterclockwise. Regulate the MVR
position on the mount and set the
recording angle. Tighten screw 1 by
turning it clockwise.
To remove the MVR from the mount,
first press tab 1. Then, holding the tab,
remove the recorder from the mount by
sliding it to the side 2 .
To remove the mount from 3M tape,
take a ruler or credit card, and push it
gently between the mount and the
windshield.
1 2
3 4
5 6
1
1
2
Соедините корпус
видеорегистратора
с креплением на 3М
скотче.
Зафиксируйте видео-
реги стратор на 3М
креплении на лобовом
стекле автомобиля
в предварительно
выбранном месте.
Отклейте защитную пленку
с 3М скотча на креплении.
Ослабьте контргайку 1 , по-
вернув ее против часовой
стрелки. Отрегулируйте
поло жение регистратора
на креплении и задайте
на правление съемки.
Зажми те контргайку 1 ,
повернув ее по часовой
стрелке.
tape mount installation
Warning! Wipe the surface of the windshield before installing.
Make sure the place of installation is dry and clean. Do not install
the mount on 3M scotch tape at temperatures below +5°C. Due
to such low temperature and the difference between the
temperature inside the car and outdoors, the 3M scotch will lose
its adhesive properties and will not be able to fix the mount
properly.
Attach the MVR frame to the 3M scotch
mount.
Remove the protecting film from the
mount.
Fix the mobile video recorder on 3M
scotch tape to the selected place on
the windshield.
Loosen screw 1 by turning it
counterclockwise. Regulate the MVR
position on the mount and set the
recording angle. Tighten screw 1 by
turning it clockwise.
To remove the MVR from the mount,
first press tab 1. Then, holding the tab,
remove the recorder from the mount by
sliding it to the side 2 .
To remove the mount from 3M tape,
take a ruler or credit card, and push it
gently between the mount and the
windshield.
1 2
3 4
5 6
1
1
2