Gazer CM50-100, User Manual

Page: 8 / 92

8
ENG
Installation tips
• For Gazer multimedia system installation, one must check that all plugs and jacksare connectedin accordance with the
connection diagram.
• Make sure that the yellow “BATT+” wire of the power cable is connected to the plus terminal of the car battery while the
red “ACC” wire is connected to the auxiliary equipment bus (+12V voltage is supplied when the ignition key is turned to
АСС position).
• Prior to installing the system, one must consider where to place the remote elements such as GPS antennas and USB
ports.
• Lay all cables under the trim.
• Connect the stock USB and AUX connectors to the multimedia system (depending on the car model).
• If your multimedia system has a built-in DVD drive, unscrew two safety screws located in the center of the top panel.
• Prior to using the device, insert a memory card in the “SD card” slot.
• To use all Gazer multimedia system features, one must connect it to the Internet.
Caution! Incorrect power connection may cause the multimedia system to malfunction or fail.
Caution! Remove the memory card only when the device is switched off .