Gazelle GT1400, User Manual, Page: 7 / 12

7
EN
CAUTION:
This tool should only be used on horizontal
surfaces.Be sure to move the tool forward in a
straight line and gently. Forcing and exerting
excessive pressure or allowing the wheel to bend,
pinch or twist in the cut can cause overheating of
the motor and dangerous kickback of the tool.
1
2
3
1.Cutting Disc
2.Base Plate
3.Workpiece
● Removing or Installing Diamond Wheel
CAUTION:
Always be sure that the tool is switched off and
unplugged before removing or installing the
wheel.
Hold the outer flange with the wrench and loosen
the hex bolt clockwise with the socket wrench.
Then remove the hex bolt, outer flange and wheel.
To install the wheel, follow the removal procedure
in reverse.
Always install the wheel so that the arrow on the
wheel points in the same direction as the arrow on
the blade case.
Be sure to tighten the hex bolt securely.
CAUTION:
Use only the original wrench and socket wrench
to install or remove the wheel.
1.Wrench
2.Socket Wrench
1
2
1.Inner Flange
2.Wheel
3.Outer Flange
4.Hex Bolt
1
2
3
4
MAINTENANCE AND CARE
CAUTION:
Always be sure that the tool is switched off
and unplugged before attempting to perform
inspection or maintenance.
● Replace the Carbon Brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip
in the holders. Both carbon brushes should be
replaced at the same time. Use only identical
carbon brushes.
1.Limit Mark
1
Use a screwdriver to remove the brush holder
caps. Take out the worn carbon brushes insert the
new ones and secure the brush holder caps.
1.Brush Holder
Cap
1
● After use
Blow away dust from the inside of the tool by
running the tool at an idle for a while.
Brush off accumulation of dust on the base.
Accumulation of dust in the motor or on the base
may cause a malfunction of the tool.
※ If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.