Gazelle GT1400, User Manual, Page: 6 / 12

6
EN
INSTRUCTIONS FOR OPERATION
● Adjusting the Cutting Depth
Loosen the adjusting nut of cutting depth and move
the baseplate up and down. When it is adjusted to the
desired cutting depth, tighten the adjusting nut to fix
the baseplate.
CAUTION:
If there is slack in the saw depth adjustment disc
bolt, the saw depth will change, so the saw depth
adjustment disc bolt must be tightened.
When cutting the concrete over 20mm, the
operation must be carried out in two steps.
Otherwise not only the motor will be damaged due
to overload, but also the working efficiency will be
greatly reduced.
After adjusting the depth of cut, always tighten the
wing bolt securely.
1.Wing Bolt
1
● Switch Operation
To start the tool, simply pull the switch button.
Release the button to stop. For continuous operation,
pull the button and then push in the lock button. To
stop the tool from the locked position, pull the button
fully and then release it.
CAUTION:
Before plugging in the tool, always check to see
that the switch trigger actuates properly and
returns to the “OFF” position when released.
1.Trigger Lock
Knob
2.Trigger Switch
1
2
● Sighting
Align the edge of the front of the base with your
cutting line on the workpiece.
1.Cutting Line
1
● Operation
Adjust the amount of water flow. Hold the tool
firmly. Set the base plate on the workpiece to be
cut without the wheel making any contact. Then
turn the tool on and wait until the wheel attains full
speed. Now simply move the tool forward over the
workpiece surface, keeping it flat and advancing
smoothly until the cutting is completed. Keep your
cutting line straight and your speed of advance
uniform.
Model
GT1400
Rated Power Input W 1400
Rated Speed /min 13000
Max. Cutting Depth mm 30
Cutting Disc Size mm Ø110×1.0×Ø20
Net Weight kg 2.9
※ Due to the continuing program of research and development, the specifications herein are subject to change
without prior notice.
Technical Data
This product is suitable for cutting on stone, marble slabs, tiles, cement slabs and similar materials with
diamond cutting disc under general environmental conditions.
This product is widely used in interior decoration, road construction, building decoration and other civil
engineering construction.
The performance and specifications of this product are shown in the table below: