Gazelle GM4560, User Manual, Page: 4 / 8

4
EN
knob on the switch button. The speed regulation has
1-6 gears, 1 for low speed, 6 for high speed.
CAUTION:Before plugging in the tool, always
check to see that the switch trigger actuates
properly and returns to the “OFF” position when
released. The machine has power-off protection
function. In case of abnormal power-off after the
machine is started, the machine can be started
normally only after the switch is reset.
1
2
3
1.Lock Button
2.Switch Button
3.Speed Control
Knob
• Hang Buckle Operation
Click the arrow in the picture to open the buckle, so
that the machine can be placed on the rope or tool
belt for temporary operation, and it can be rotated and
closed when not in use.
• Operation
Switch on the tool and wait until the blade attains full
speed, then press the shoe against the workpiece and
start cutting operation.
CAUTION: Too much force can cause the blade to
bend or twist, which can cause the blade to snap.
• Metal Cutting
Always use a suitable coolant (cutting oil) when cutting
metal. Failure to do so will cause premature wear of
the blade.
1
1.Feed Coolant
MAINTENANCE AND CARE
CAUTION: Always be sure that the tool is switched
off and unplugged before attempting to perform
inspection or maintenance.
• Checking Mounting Screw
Always check whether the mounting screw is tight. If
found loose, it should be immediately retightened to
avoid accidents.
• Maintenance of the Motor
The motor unit winding is the very “heart” of the power
tool. Exercise due care to ensure the winding does not
become damaged and /or wet with oil or water.
• I nspecting the Carbon Brushes
Remove and check the carbon brushes regularly.
Replace when they wear down to the limit mark.
Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at
the same time.
1
1.Limit Mark
Use a screwdriver to remove the brush cover, take
out the worn carbon bush and replace a new one, and
then tighten the brush cover securely.
※ If the replacement of the supply cord is necessary,
this has to be done by the manufacturer or his agent
in order to avoid a safety hazard.