5. Your tent should now be freestanding. Locate a zippered door and
walk inside the tent. Once inside of the tent, place one hand on the
bottom of a roof hub and push up until the roof pops into position.
[ SEE FIGURES 5 & 6 ]
NOTE: This step should be done with caution as there is a lot of
tension
on the roof hub and pole assemblies.
6. Locate the (2) large diameter corded poles and assemble the corded
sections together to create one long pole each. Place the assembled
poles in the small pockets located at each inside corner of the vertical
screen door. Fasten poles to the vertical seams with the hook and loop
tie located about halfway up the seam.
[
SEE FIGURE 7 ]
7. Move outside of your tent and begin securing your tent to the ground
by using the provided stakes and tie down ropes. The stakes can be
fastened through each of the tent grommets, and the tie down ropes
can be tied around hub eyebolts and tightened to a stake in the
ground. Use adjustment slides on the rope to achieve proper tension.
[
SEE FIGURE 8 ]
8. Hammer stakes through the grommets located in each corner
completely.
CONVERTING SCREEN SECTION
INTO A SLEEPING SECTION
This tent comes with a section that is convertible between a screened-in
sitting/storage area to a private sleeping area for up to four people.
Follow these simple steps to complete the transition.
1. Make sure that the large diameter corded poles are assembled into
the small pockets as described in
[ STEP 6 ]
of
SET-UP
INSTRUCTIONS
2. Zip up the zippered door coverings on either side of the vertical
screen door.
3. Find the privacy panels located on the left and right of the large
internal door of the tent. Unroll these along the side screen panels
and use the plastic hooks to secure the panel taut to the fabric loops
located in the top and bottom corners, close to the ends of the
corded pole.
4. Follow directions in the
INSTALLING FLOOR
section to complete this
conversion.
NOTE: The rainfly must be assembled onto the tent with the large
triangular
panels fully extended to protect this area from the rain.
The privacy panels are not intended to keep this area dry.
INSTALLING FLOOR
1. The tent must be set up before installing the floor.
2. Spread the floor out loosely inside the tent.
NOTE: There are colored alignment tabs both at the center of the
tent panels and the center of each edge of the floor. Make sure
that you have lined appropriately colored floor tabs with the
corresponding color tab on the wall panel to ensure the correct fit.
3. Start at the center of each wall using the colored aligning tabs as
guides. Press the hook and loop strips together, working towards
the corners.
[ SEE FIGURE 9 ]
NOTE: The Gazelle camping / leisure tent can be taken down and
stored with or without the floor attached.
5
6
SCREEN MESH END
NO RAIN FLY
SMALL
POCKETS
HOOK &
LOOP TIES
7
8
INSIDE WALL BASE
9
