ZZZ-202.43202.0114-21.GP.EN.doc WEB VERSION
10
Step 9
:
1. Slide the indicated
polycarbonate panels into the
spaces between the rafters,
using the top groove of each
rafter. Ensure the side meant
to face the sun is on the
outside. Use a rubber hammer
to carefully tap each panel
into the grooves.
Step 10:
1. Insert the middle roof joints in between the rafters and slide them up under the polycarbonate
panels. Tap lightly to ensure the panel is fully in the slot. Seen from above, most of the joint as
well as the drain holes should be beneath the roof panels.
2. To adjust the middle joints to line up : once all polycarbonate roof panels are in place, use a
small piece of wood and hammer, then tap down on the middle of the joint bringing it down and
holding at the same time the joint and top polycarbonate.
3. Do not tap too hard.
