Section 1 - Establishing Euronet
Even though all Angel LED fixtures are tested at our factory, we suggest you perform your own initial test and
configuration prior to installing your fixtures over your aquarium. This is a great way get a better understanding of
your new LED fixtures without having to stay perched above your aquarium, and the Angel will save your setting so
anything you configure will be saved.
1. Place each Angel fixture on the floor or a table, face up – but do not plug into power yet.
•
This is also a great time mount your fixtures if you’re using our rail system.
•
Take care to never look directly into the fixture when powered on.
2. Next, plug in power to the units one at a time.
3. As you power additional units, enable the Euronet link. Here's how:
•
Press the configuration button on first fixture for 2 seconds, and then immediately press the
configuration button on the second fixture for 2 seconds.
•
You will see the indicator LED pulsing rapidly until the two units link. After linking, the indicator lights
will blink slowly to indicate pairing.
•
Repeat this step one at a time for each new fixture added to your system until complete.
•
We suggest using the button on the first fixture each time you pair a new fixture to the network.
•
Wait about 30 seconds between pairings to insure all units are properly synchronized.
Power Plug
Configuration
Button
Indicator LED
(inside the fixture)
Connecting Multiple Lights to Euronet
Up to 100 fixtures!
…
The number of total systems depends on your home networks WiFi limits
Main Display Tank
Office Tank
SPS Frag Tank
…
…
…
…
…
1
Note:
Please refer to
Section 4
for a complete list of the Configuration Button functions.
TM
