NOELLE S554.100 |
User Manual
Equipment Setup | 9
Newborn Power Supply
Connect the power adapter labeled Newborn to the power input located
on Newborn’s right side.
Always operate Newborn with the power supply connected.
3.2 Control Computer
The laptop computer is the simu-
lator’s control center. Startup and
control commands are sent from
the Gaumard control software (UNI)
to the simulator using the wired
communication module shown in
the next section.
Review all manufacturer warnings and procedural information included
with the laptop’s documentation before continuing.
Communications Module
Follow the steps below to connect the communication module to the
simulator and the laptop computer.
UNI controls only one simulator at a time. To switch between NOELLE
and Newborn, first exit the UNI software and reconnect the communi-
cations cable to the simulator you wish to control.
WARNING: Do not connect the simulator to Ethernet cards, LAN
networks or unauthorized diagnostic equipment. Doing so may cause
damage to the system.
1.
Connect the communication
cable to the USB communica-
tion module.
Summary of Contents for NOELLE S554.100
Page 2: ......
