GAUGEMASTER
DCC75
TECH 6 SOUND CONTROLLER
Operation
The TECH 6 operates as a normal DC power pack. It is also a sound controller that can operate all of the sounds in
your locomotive if it contains a DCC sound decoder. It has two modes of operation, STANDARD (STD) DC for non
sound equipped locomotives and DUAL for operating sound equipped locomotives.
Traditional DC Operation Mode
If you wish to operate a standard, non decoder equipped loco, press
SEL
key to select
STD
mode. You can use the
throttle knob to control speed and the direction <> key to change the locomotive direction.
Power and Sound Control Mode
This mode is to run and control the sounds in your decoder equipped loco. Press the
SEL
key to select
Dual
(dual;
meaning power with sound) mode. You should be able to control your loco with the throttle knob and change
locomotive direction with the direction key. If it does not respond, press the
SHIFT
key and then press
9
,
9
. This will
reset your loco within 5 seconds.
Note if your locomotive has been used with a DCC system and its address was set to other than address
number 3, it will need to have its address reassigned after it has been run using the Tech 6.
You can turn on / off the headlight by pressing
0
. You can turn on / off the Bell by pressing
1
. To blast the horn press,
2
. To control functions F3 to F9, press 3 to 9. To control F10 to F28, press
SHIFT
and then press the desired two digit
number.
Adjusting Feature Variables
1. Press
P
, all LEDs will turn on.
2. Press any one of the numbered buttons listed below to adjust the individual feature:
•
Button
2
is used to set
Start Voltage (factory set at 0)
•
Button
3
is used to set
Acceleration momentum (factory set at 0)
•
Button
4
is used to set
Deceleration momentum (factory set at 0)
•
Button
5
is used to set
Top voltage (factory set at 32)
3. Now
press
ENT
, all LED’s will turn off.
4. Buttons 2, 3, 4 & 5 generally use a range of values
*
from “0 to 32”. Using the keypad, select a number range
from 0-32.
5. Finish the process by pressing
ENT
again. The Tech 6 will return to run mode and will memorize your setting
until you wish to make another change.
If you wish to make another adjustment, repeat the above steps.
Some decoders may have a different range of adjustments. Please read your loco manual or decoder instructions and
refer to CV numbers 2,3,4,5 for their range of adjustments.
Adjusting CV’s
1. Press
P
, all LEDs will turn on.
2. Input the CV number you want to adjust and then press
ENT
, all LEDs will turn off.
3. Input the CV value
4. Finish the process by pressing
ENT
again. The Tech 6 will revert back to run mode and memorize your
settings until you wish to make another change.
If you want to adjust another CV, you have to repeat the above 4 steps. For more information on CV definitions and
their values, please read your loco manual or decoder instructions.
