User Manual
Page 5
Installation
Mounting the plinth
Before using the FM-50 loudspeaker the metal plinth has to be mounted. Start by removing the speakers from the carton boxes:
WARNING:
Please note that using spikes under your speakers will invariably leave marks on your fl oor or any other surface that you place
the speakers on. Gato Audio cannot accept any responsibility for any type of damage to fl oor, furniture surfaces, marriage or anything
else resulting from the use of spikes. It is up to you and your family to consider carefully beforehand whether the improvements in sound
quality and performance will outweigh the possibility of any inconvenience caused.
Using spikes
1.
Place the 4 spikes in
the holes of the plinth
by screwing them in
clockwise
1.
Leaving the foam pieces on, turn
the speakers upside down. Then
remove the two foam pieces from
the bottom of the speaker.
2.
Turn the spikes up or down
to adjust the speaker height
from the fl oor, so all spikes
are touching the fl oor at the
same time
2.
Mount a plinth on each speaker
with 5 cylinder screws with the
supplied hex screw driver.
3.
Turn the fastener clockwise
until it is positioned tightly
against the plinth. Make
sure the spike does not
turn during the process by
grasping the top with your
other hand if necessary
3.
You can now turn the speaker
upright again.
4.
The spike feet can be
applied to protect the
surface underneath the
spikes
Summary of Contents for FM-50
Page 1: ...FM 50 User Manual...
