Gateway GT4015, Hardware Reference Manual

Page: 21 / 78

CHAPTER 3: Maintenance Basics www.gateway.com
18
4
Remove the two drive retention screws, then slide the drive forward and
out of the drive bay.
5
Note any jumper settings on the old drive and set the jumper on the new
drive to be the same.
6
Slide the new drive into the drive bay, line up the screw holes on the drive
bay with the screw holes on the drive, then replace the two drive retention
screws.
7
Reconnect the drive cables using your notes from Step 3 .
8
Replace the front bezel by following the instructions in “Replacing the
front bezel” on page 14 .
9
Replace the side panel by following the instructions in “Replacing the side
panel” on page 14 .
Replacing the memory card reader
Tips & Tricks
You need a Phillips screwdriver to replace
the memory card reader.
To replace the memory card reader:
1
Remove the side panel by following the instructions in “Removing the side
panel” on page 12 .
2
Remove the front bezel by following the instructions in “Removing the
front bezel” on page 13 .
Drive retention screws
Drive retention screws