Gateway Convertible notebook, Service Manual

Page: 57 / 74

www.gateway.com
53
Replacing the fingerprint reader
Tools you need to complete this task:
v
Screws removed during this task:
To replace the fingerprint reader:
1
Complete the steps in “Preparing the convertible notebook” on page 5 .
2
Remove the bay module by following the steps in “Replacing a bay module” on page 7 .
3
If the convertible notebook has wireless networking built in, unplug the wireless antennas
by following the steps in
“Replacing the IEEE 802.11 wireless card” on page 16 .
4
Remove the hard drive by following the steps in “Replacing the hard drive” on page 21 .
5
Remove the keyboard cover by following the steps in “Replacing the keyboard cover” on
page 27 .
6
Remove the keyboard by following the steps in “Replacing the keyboard” on page 28 .
7
Remove the LCD assembly by following the steps in “Replacing the LCD assembly” on page 40 .
8
Remove the palm rest by following the steps in “Replacing the palm rest” on page 50 .
9
Turn the palm rest over so the back side is facing up.
Flat-blade driver Scribe or non-marring tool - OR -
Phillips #0 screwdriver
1 black 2.5*8.0 (Optional
bay module security
screw) 1 chrome 2.5*5.0 (Hard
drive)
2 chrome 2.0*3.0
(Fingerprint reader)
2 black 2.5*8.0
(Keyboard)
4 or 6 black 2.5*8.0 (LCD
hinge to notebook)
14-16 black 2.5*8.0
(palm rest-bottom)
2 chrome 2.0*5.0
(palm rest-hard drive
bay)
3 chrome 2.0-0.4*2.0
(palm rest-modular
drive bay)
1 black 2.5*8.0 (palm
rest-top)