Gateway Convertible notebook, Service Manual

Page: 44 / 74

Replacing convertible notebook components
40
Replacing the LCD assembly
Tools you need to complete this task:
v
Screws removed during this task:
To replace the LCD assembly:
1
Complete the steps in “Preparing the convertible notebook” on page 5 .
2
If the convertible notebook has wireless networking built in, unplug the wireless antennas
by following the steps in
“Replacing the IEEE 802.11 wireless card” on page 16 .
3
Remove the screws on the bottom that secure the LCD panel hinge to the chassis.
4
Turn the convertible notebook over so the top is facing up.
5
Remove the hinge covers by following the steps in “Replacing the hinge covers” on page 26 .
6
Open the LCD panel to the fully open position.
Important
The number of screws varies by convertible notebook model.
Caution
Be careful not to use too much force when opening the LCD panel.
Flat-blade driver Scribe or non-marring tool - OR -
Phillips #0 screwdriver
4 or 6 black 2.5*8.0 (LCD
hinge to notebook)
Screw
Screw
Screw
Screw