4 Gateway ALR 7200R User’s Guide Supplement
Introduction
The ALR 7200 minitower chassis provides the capability to easily convert
into a fully functional, standard 19" rack-mountable drawer. To accomplish
this, a Rack Conversion Kit is available. If your system came pre-
configured for rack installation, you may skip this section and proceed to
Chapter 3.
Before proceeding, turn off system power and disconnect all peripherals.
Remove Existing Panels
1.
Remove the three screws located on the rear of the system.
2.
Slide the top panel back, then pull the cover up.
3.
Remove the two screws located on the rear of the system, left side.
4.
Slide the side panel back, then pull the cover off.
5.
From the inside of the chassis, remove the two screws securing the
bezel to the chassis.
3437.boo Page 4 Wednesday, October 7, 1998 4:01 PM
