Gates Underwater Products
•
5111 Santa Fe Street, Suite H • San Diego, CA • 92109
858.272.2501 • 800.875.1052 • Fax 858.272.1208 • [email protected] • www.GatesHousings.com
01/06/04
7
Contrast
Brightness
Color
Monitor Adjustment
The EM253 has three adjustments for brightness, color and contrast. These
adjustments can be found on the inside rear half of the housing (see photo).
While the monitor is pre-adjusted at the factory, Gates recommends the monitor be
further adjusted to match the camera being used. This will ensure a consistent match
between the monitor and the image actually being recorded.
Matching the camera and monitor should be done in a darkened area to allow good
viewing of both the monitor and the camera electronic viewfinder (EVF).
With the camera on and the monitor plugged in, compare the image on the EVF to the
monitor. Separate the monitor halves, make a small adjustment to the brightness,
contrast or color control, then mate the halves again and view the results. (It is not
necessary to secure the latches. Simply mating the halves should produce an image).
Fine tune your adjustments until you are satisfied that the image on the monitor
accurately reflects that being seen in the EVF.
Customer Support
If you have any questions or require further assistance with your EM253 External Color
Monitor, contact your dealer or Gates directly and we’ll be happy to assist.
Email:
Phone:
858-272-2501
Fax:
858-272-1208