The AX700 Setup
Page 10
When using Z90 Camera
Secure “SDI OUT” cap
onto the SDI out connector.
CAUTION:
Failure to make sure this cap is attached may prevent the controls on the
rear of the housing from functioning or prevent the housing from sealing.
(
NOTE
: when using Optional SDI Surface Feed, the cap must be completely cut off.)
Switch the camera to
‘MANUAL’ if you plan to use the ND filters.
o
This switch is just above the ND filter slider on the back of the camera.
Otherwise, set the camera to ‘AUTO’, and the camera will automatically add
ND Filters as needed.
Turn ND Filter control on camera to the CLEAR / OFF position.
o
This will aid in aligning the ND Filter control on the housing.
o
NOTE:
Switch to CLEAR even if you do not want to use manual ND filter
control. The rear half of the housing may not mate properly if this step is
skipped.
Install Fully Charged Battery and SD Cards.
Z90 SDI OUT cap must
be securely attached or
completely cut off.
