Gates 7480-7006, Safety And Operating Manual

Page: 15 / 24

13
HOSE PREPARATION
GC16XD MINI CRIMPER & PUMP SAFETY & OPERATION MANUAL
TWO-PIECE COUPLINGS
Cut Hose to desired length.
Using Gates Crimp Data Manual # 35019 (Ind),
428-7365 (Auto) select the correct stem and furrele.
Or, log onto www.gates.com/ecrimp for the latest crimp
information on line.
Place the ferrule over end of hose. If skiving is required,
see instructions in Gates Hand Skiver manual
# 35019-W.
Lubricate the first two or three serrations on the stem
with lightweight oil (SAE 10W).
Clamp the stem in vise on hex portion, and push hose
onto stem. Hose should be flush against stem shoulder
(See cutaway drawing).
Push ferrule so it rests against hex of stem. Hose and
coupling are now ready for crimping.
MEGACRIMP
®
PRE-ASSEMBLED COUPLINGS
Cut Hose to desired length.
Using Gates Crimp Data Manual #3509 (Ind),
428-7365 (Auto)select the correct MegaCrimp
®
coupling. Or, log onto www.gates.com/ecrimp for
the latest crimp information on-line.
Place a visable mark on the hose cover at the
insertion length shown in the crimp data manual.
Insert coupling into the hose until the mark lines
up with the end of the coupling furrule.
Hose and coupling are now ready for crimping.
CAUTION:
A new hose and end fittings (stem/ferrule) must be used when building a hose assembly. Re-using any compnent
will seriously affect performance and could result in serious injury of property damage.
1.
2.
2.
3.
4.
5.
6.
CAUTION:
See Hose Assembly Guide of the Gates Crimp Data
Manual # 35019 (ind) and 428-7365 (Auto) or log
onto www.gates.com/ecrimp for more details.
1.
3.
4.
5.